Synthetics Sealing

Synthetics Sealing

Nanosunco ® Synthetics Sealing is a temporary alcohol-based coating based on chemical nanotechnology, which generates an easy-to-clean effect on synthetic surfaces (polyester, PMMA, PC). The rubbed-on material generates a thin film on the surfaces, which reduces the adherence of dirt and foreign material and better rolls of water. Coated surfaces are particularly easy to clean.

Benefits

• Temporary alcohol-based coating
• Generates easy-to-clean effect
• Hydrophobic and dirt-resistant
• Easy-to-clean after application

Use

All synthetic surfaces , plastics , polyester, PMMA , ….

Specifications

Dilution: None

Hardening/Drying: 15-30 minutes; completely hardened after approx. 6 hours.
Processing Temperature: +5°C till +25°C
Storage and Service Life: See imprints on bottles and jerry cans.
Keep well locked in original trade units; protect from direct sunlight and frost.
Storage Temperature: +5°C till +25°C
Environmental Impact: Do not use it below +5°C.

Preparation and Application

Thoroughly free the surface from dirt, oil and greasy staining. Clean the surface with Grey giant sponge and remove the residue. Then apply Nanosunco Cleaning Agent. Rinse with plenty of water afterwards. Surfaces must be clean, dry and grease-free prior to coating. Test the application on an unobtrusive spot or a sample surface.

Important: It is important not to touch the surface with your hands after cleaning. Start refining immediately after cleaning. Do not clean the surfaces mechanically or chemically for 2 hours after the refinement.

Apply through rubbing using a clean piece of cloth. Economically spray the material on the surface and spread with circling movements on the clean surface. The applied quantity is about 10-25 ml per sqm.
The applied material needs at least 15-30 minutes to dry. The easy-to-clean effect will be generated about 30 minutes after furbishing. If humidity is high, allow for a longer hardening time (up to a few hours).

Quality Check: The water should generate drops but not an even coat on the complete surface. If the temporary easy-to-clean effect gets weaker, you may refresh the effect by proceeding based on the initial treatment.

Important Notes: Cleaning coated surfaces: Aggressive cleaning agents (extremely acid or basic, abrasive milk) are not required, as any staining does not adhere strictly to the surface. Clean the surface with a sponge and mild cleaning detergent (i.e. Nanosunco Cleaning Agent), when roll-off effect weakens. The coating still requires the regular cleaning of the surface.

Important: Keep out of reach of children!