Nanosunco Fire prevention products are fire prevention impregnation in accordance with DIN 4102 – B1 for the dry interior with the required test certificates and verifications. In the case of a fire, Nanosunco® Fire prevention develops non-combustible gases and results in the carbonization of the impregnated material. No toxic gases or substances containing halogen are released.
• Fire protection impregnation for different surfaces
• standardized in accordance with DIN 4102
• B1 and straw decorations with test certificate
Nanosunco Fire prevention products :
BS Cardboard
BS Syntex
BS Timber
BS Varnish
Master BS Textile
Dilution: none
Processing Temperature: +5°C till +30°C
Protect from direct sunlight.
Active Components: Water-based solution of nitrogen and
phosphate bonds
Does not contain solvents or halogen bonds.
Storage and Service Life: Can be stored for at least 12 months
Seal opened packaging unit well.
Storage Temperature: +5°C till +25°C
Protect from frost and direct sunlight.
Environmental Impact: Do not use it at temperatures below +5°C.
At temperatures above +25°C, coat smaller surface sections.
In each case either way, test the suitability with the surface on an unobtrusive spot. Clear the surface carefully of dust, grease, wax and resin and separating particles.
Shake well before use. Depending on the type of material, different types of application through immersing or spraying are possible.
Important: The impregnation is not resistant against the exposure to water.
Important note: The proof of flame retardant properties according to the test certificate only refers to the serviceable original solution.
: The wet fitting of fire protection impregnation must be at least 800 ml/kg on material.
Permanent Effect: If processed appropriately, the impregnation can be effective for many years.
Note: The thinner added to set the viscosity should not exceed 10%. If too much thinner is added, the quality may be reduced.
At least 800 ml per kg material
LabroClean – Pre-treatment and Cleaning 
